← Kitchen field guides

Will a zero-clearance refrigerator handle hit the wall?

A counter-depth fridge can fit the opening and still catch the wall with its right handle. Measure the gap beside the case, then check how far the wall continues past the door hinge.

Where does your wall end?

Face the opening and sketch it from above. Measure from the rear kitchen wall to the front edge of the right wall or trim. From that same starting point, mark where the new fridge’s right hinge will sit. Include the planned space behind the fridge. The handle on the closed door sits farther forward on many models, so use the pivot as your reference.

For example, a wall ending 30″ from the back wall reaches 1½″ past a hinge installed at 28½″. That puts the wall alongside part of the moving door. Choose Partway / unsure in the checker. For a closer check, take the side gap and the 1½″ projection to a showroom with that exact model. Ask the salesperson to hold a piece of cardboard where the wall ends and slowly open the door with the original handle in place.

If a cabinet filler is proposed, measure the clear air gap that will remain at door and handle height. A strip of filler occupying that space can itself become the surface the door meets.

Two LG handles, the same ¼″ gap

Suppose the right wall runs alongside the open door, and all other installation clearances are met. Both of these LG fridges are sold as counter-depth models with zero-clearance hinges. Their upper-door handles give a buyer two different choices.

Which arrow applies to a Samsung Bespoke?

On Samsung RF70H25GERAA and RF70H25HERAA, follow the bar handle in the 90° top view. On a long wall it projects about 1¾″ (44 mm) to the side of the case, so the handle would hit a wall just ¼″ away. The short cabinet sides in the installation drawing end near the hinges and leave the projecting handle room to swing. RF70H25GERAA drawing, page 2 · RF70H25HERAA drawing, page 2

A 2″ gap beside a long wall is a closer call. Samsung’s V7 guide specifies 3¾″ for a wall-side 90° opening. Its V10 drawing keeps the handle dimension and asks buyers to check for interference. Hinge Index shows Needs data at 2″ for both models. Samsung’s earlier wall allowance, page 2

Record your wall and hinge positions · Compare the 20 models with your wall measurements · Check whether the inside drawers can come out